|
|
|
|
|
|
Condition: New
Manufacturer: Unknown
|
|
|
This is a squeezable plastic clock oiler with a 3.5 inch metal feeding tube screwed onto a 3 inch barrel that will reach inside those hard-to-reach places in Grandfather clocks, Anniversary clocks, Mantle clocks, Small and Large Wall clocks, Shelf clocks or any other mechanical or electrical clock you may have.
Clocks with mechanical gears and bushings need oiling every 5 to 8 years or they begin to wear very fast. If you have a keepsake clock you want to keep, try this oiler with its controlled drip when applying very slight pressure on the bottle of the oiler. You can even oil in an upward direction briefly if you get the metal tube full of oil and they rotate the tube upward while keeping slight pressure on the tube.
This oiler works wonderful and will do a very nice job for you. Always apply oil very sparingly on clock parts and only oil the bushings where the gear spindle goes through the frame. Don't over oil and saturate the clock parts or they will collect dust which is the opposite of what you want to achieve. This oiler will probably oil 50 to 75 clocks or more without a problem.
The bottle measures approximately 2.75 inches long by 7/8 inches across. The cap or tip of the oil tube is a friction fit cap that clamps down tight on the oil tube so there are no leaks. You can even lay it down for storage without any leak exposure if you press the cap on tight. |
|
|
|
|
Click Here For
Top of Page
|
|
